Lightburn laser cutter6/19/2023 ![]() ![]() If a tab needs to be moved, simply click on it again and drag it to a new location, even on another shape.įinally, you can delete a tab by double-clicking or shift+clicking the tab. The system will, however, limit how close any two tabs can be based on the currently set tab size. ![]() Tabs default to 0.5mm in width and you can place many tabs on any shape. Simply click where you would like a tab, and a red circle will apear where you clicked, denoting that a tab will be placed there. Once the Add Tabs tool is selected you will see the Insert Tab cursor ( ) when hovering over a shape which you can add a tab to. You can only add tabs to shapes that are in Line mode. Once that is done, you will see the "Add Tabs" tool is available: In the example below, the left square has no tabs applied, while the right has a single 1mm wide tab on each side.įirst, note that you will need to disable Beginner Mode in the LightBurn Settings otherwise the tabs functionality will not be available. Simply put, it's where you skip a very small section of a cut, often less than 1mm in length. The concept comes from the CNC world but is much simpler in the context of a Laser. Sometimes it is helpful to include tabs (sometimes called bridges) in objects that you are cutting out so that they do not fall out immediately but can be removed later.
0 Comments
Leave a Reply. |